Swarovski Crystal Iron-Ons and Transfer Instructions

How to apply crystal iron-on transfers
How to make crystal iron-on transfers

How to apply iron-on transfers:

1. Pre-wash garment before applying anything to your fabric.
2. Carefully remove the white backing paper from the clear adhesive film.
3. Position and then press motif onto fabric. The clear adhesive film will hold the motif in place.
4. Turn fabric inside out. Cover area with a pressing cloth or face cloth.
5. Pre-heat iron for 3 minutes on highest heat (usually cotton or linen). NO STEAM! Iron for approximately 45 to 50 seconds. You are melting the special glue on the back of the crystals.

How to make your own iron-on transfers:

1. Get pattern and place in plastic cover.	2. Take the white backing off of your mylar paper.
3. Put the sticky clear mylar, sticky side up, over your pattern and tape down.	4. With either flat-nose pliers or a long tweezer (found in craft stores), put crystals on upside down (glue side facing up).
5. When all stones are on the mylar paper, put sticky side of mylar onto the garment that you want to have ironed permanently.	6. At this point you are ready to iron on your creation using a wash cloth or ironing cloth.  Pre-heat iron for 3 to 5 minutes, cover your pattern with ironing cloth, let iron set on cloth for approximately 40 to 45 seconds, let cool 2 minutes, slowly remove mylar (if any are not totally glued down, iron again in that spot). There is no such thing as over ironing.  You can do this process repeatedly.  For washing, turn garment inside out and wash warm or cold. Put in dryer on knit setting.